Transmitter Controls; The Remote Control System; Binding Process - XciteRC 3i FHSS Hobby-Spec Mode D'emploi

Transmitter controls

EN
EPA Steering
Servo-Reverse
Power-Switch
LED ST.D/R
Charging Jack
Servo-Reverse
EPA Throttle

The remote control system

Here you get an overview of the remote control system and its various features and settings. Before the first
flight, you should have read and understood all these functions and settings.
• Make sure that the transmitter is turned off - ON / OFF switch in position O.
• Now open the battery compartment cover on the bottom of the transmitter and insert eight AA batteries
(or rechargeable batteries) into the battery compartment of the transmitter. Pay attention to the correct
polarity!
• Close the battery compartment cover and turn on transmitter – push ON / OFF switch in position I.
• Connect and install the receiver and servos.
WARNING: Be careful with the installation of the receiver. Never bend or shorten the coaxial
antenna wire! The actual „antenna" is the stripped end of the antenna wire and must be installed
in the vehicle so far above as possible. Avoid damages of the antenna cable!

Binding Process

1. Turn on the transmitter and receiver.
2. If the receiver is not bound to this transmitter, the receiver LED will light up red. Push the BIND-button on
top of the receiver, the LED will turn to green.
3. The biding is succesfull, when the BIND-LED turn into solid green.
16
All manuals and user guides at all-guides.com
Antenna
Steering
Power LED
Failsafe
Throttle
Batt. (4.8 - 6.0 V DC)
CH 3 = AUX
-
S +
CH 2 = Throttle
CH 1 = Steering
Transmitter controls · Binding
AUX-Channel
Steering Trim
Steering Wheel
Throttle Trim
Throttle Lever
Steering ST.D/R
Battery Case
XciteRC 3i FHSS Hobby-Spec 2.4 GHz