EN
Mixer (MIX)
This function allow custom to apply mixing between the steering, throttle, and channel 3 channels.
There are main channel and sub-channel in the MIX selection. The servo travel value of the sub
channel is changed along with the change of the main channel according to the setting rate.
1. Press "ENTER" to see FUNCTION MENU
2. Use the +/- Keys to select the BR_MIX function and press ENTER.
3. Press ENTER to select a item.
4. Firstly main channel setting. Select channel No. (ST, TH, AUX) by "+" or "-". L and R separately corres-
pond to the rate of Left and Right servos of the main channel mix.
5. Secondly sub channel setting. Select channel No. (ST, TH, AUX) by "+" or "-". L and R separately corre-
spond to the rate of Left and Right servos selected in the sub channel.
6. Third Press ENTER to select EN item. Use +/- to select "ON" to enable the function, and "OFF"
to disable the function.
7. Press EXIT twice to save and return to FUNCTION MENU, press EXIT again to return to the Main
Screen.
Example:
ST
L 50%
TH
L 20%
EN
„ON"
TH HOLD
This function allows the Throttle Servo to be set to a percentage of the total travel range. This is
an alternative to using the motors choke when starting up the model. Throttle hold can be performed by
pressing the switch to stop the engine. It can be performed for accident braking. When pressing the
switch, throttle trigger doesn't work until the switch is pressed again.
1. Press "ENTER" to see FUNCTION MENU
2. Use the +/- Keys to select the TH HOLD function and press ENTER.
3. Use the +/- Key to change the value.
4. Press EXIT twice to save and return to FUNCTION MENU, press EXIT again to return to the Main
Screen. TERMS: VALUE: Throttle hold position. Range: -120% to +120%.
32
R 30%
If throttle servo is 60% on the right and rudder servo is 50% on the right,
and then after setting, throttle servo is: 50*30%+60%*50%=45%. Throttle
R 50%
servo will act along with the action of STEERING servo.
Operation
TH.Hold
XciteRC 3i LCD FHSS Pro-Spec 2.4 GHz