Steering Range (St.d/R); Sub-Trim (S_Trim); Servoreverse (Rev) - XciteRC 3i LCD FHSS Pro-Spec Mode D'emploi

linkage. EPA adjusting value range: 0~120 %, default is 100%
1. Press "ENTER" in the power on interface and enter function menu. Press "+" or "-" to choose
"EPA". And press "ENTER" and enter EPA adjusting interface.
EN
2. Press "ENTER" to choose each adjusting item, and then press "+" to increase and "-" to decrease
the value of the corresponding item.
3. Press "EXIT" to save your setting and leave EPA interface, and back to the function menu interface.
TERMS: F-FORWARD,B-BACK,ST-STEERING, TH-THROTTLE,AUX-AUXILLIARY

Steering range (ST.D/R)

D/R is used to change the action range of steering servo when turning the steering wheel. Increasing D/R
will make the steering wheel action more sensitive. --D/R adjusting value range: 0~120%, POS0 default
value is 100%,POS1 default value is 70%. -- Press the ST.D/R dial to select POS0 or POS1, and the value
will display in the LCD when it is on the main screen.
1. Press "ENTER" to see FUNCTION MENU.
2. Press "+" or "-" to choose D/R, and press "ENTER" to enter D/R adjusting interface.
3. Press "+" to increase and "-" to decrease D/R value.
4. Press "EXIT" to save your setting and leave D/R interface, and back to the function menu interface.
TERMS: POS-POSITION

Sub-Trim (S_TRIM)

Use this function to adjust the neutral position of the steering and throttle servos. SUB TRIM adjusting value
range: -100 - 100. Default is 0.
1. Press "ENTER" to see FUNCTION MENU.
2. Press "+" or "-" to choose TRIM, and press "ENTER" to enter SUB
TRIM adjusting interface.
3. Press "+" to increase and "-" to decrease SUB TRIM value.
4. Press "EXIT" to save your setting and leave SUB TRIM inter face, and back
to the function menu interface. TERMS: ST-STEERING, TH-THROTTLE

Servoreverse (REV)

This function reverses the direction of operation of the servos related to transmitter steering, throttle, and channel
3 operation.
1. Press "ENTER" to see FUNCTION MENU.
2. Press "+" or "-" to choose REVERSE, and press "ENTER" to enter REVERSE ad-
justing interface.
3. Press "ENTER" to choose each Channel.
4. Press "+" to increase and "-" to choose "REV" or "NOR".
5. Press "EXIT"to save your setting and leave REVERSE interface, and back to
the function menu interface.
Note: However, when the position set by trim or sub trim shifts from the center,
26
Operation
0
50% 50%
100% 100%
120% 120%
ST.D/R
XciteRC 3i LCD FHSS Pro-Spec 2.4 GHz