Operating The Remote Control; Aux Channel Function (Ch3); Steering Dual Rate (St.d/R) - XciteRC 3i FHSS Hobby-Spec Mode D'emploi

Operation
Bind-LED
NOTE:
1. During Frequency Pin Setup, make sure that Tx and Rx is one meter away, and around 10 meters there
is no similar (2.4 GHz) device.
2. Once success, no need to process the Binding again for that receiver.
3. If fail in Setup (BIND-LED still lights red), please try again patiently.

Operating the remote control

• Run your car never with low transmitter or receiver batteries, the Power-LED must lit green.
If the Power-LED on the transmitter lits red, stop running your model and change or recharge
batteries!
• Never forget switch off the radio after running your vehicle , otherwise the batteries do not last long.
• Turn on the transmitter first, then the vehicle.
• After driving first turn off the vehicle, then the transmitter.
• For optimal use first check the steering and throttle trim positions.

AUX Channel function (CH3)

The AUX-Channel is designed purely as a control channel and is not adjustable. The connected servo makes
a movement of 90 °.
With the switch in position „AUX", the servo rotates clockwise, in „OFF" position counterclockwise.

Steering Dual Rate (ST.D/R)

Steering Dual Rate is used to change the action of steering servo when turning the steering wheel. The de-
fault setting is 100%. The adjusting value range is 20% - 120%.
Flash
1. Press INC-Button, the ST.DR-LED flash green, showing the value of the steering servo is increased. When
LED appears all along red, ST.D/R reaches maximum value.
2. Press DEC-Button, the ST.DR-LED flash in green, showing the value of the steering servo is decreased.
When LED appears all along red, ST.D/R reaches maximum value.
3. The ST.DR-LED appears red, showing that exactly 20%, 100% and 120% is selected, otherwise the LED
disappear.s after adjusting.
XciteRC 3i FHSS Hobby-Spec 2.4 GHz
All manuals and user guides at all-guides.com
Bind-button
100%
AUX
0
100%
ST.D/R-
button
0
20% 20%
100% 100%
120% 120%
EN
17