Ford VJL3Z-84501A42 Addendum page 3

Cansiter
Mounting Screws
Front
(10-32 x 7/16")
Cover
Table of Contents
Pg. 1 Exploded view, pre-assembly guidelines
parts check lists, box contents, tools required
Pg. 2 Steps 1 - 3, Cover assembly
Pg. 3 Steps 4, Positioning the cover and rails
Pg. 4 Step 5, Install clamps
Pg. 5 Step 6, 7 & 8, Cover measurements and adjustments
Pg. 6 Step 9, Install drain tubes
Pg. 7 Use & maintenance
Pg. 8 Final notes, Rail System installation information
Pg. 9 Warranty
Pg. 10 French
Pg. 19 Spanish
Pre-assembly Guidelines
Please read and follow the instructions before assembling the bed cover.
Keep the boxes and packaging until the installation is complete. Unpack carefully to prevent scratching.
DO NOT remove any protective films from the cover and canister until after the installation is complete.
DO NOT USE A LUBRICANT OR LOCTITE BRAND PRODUCTS ON THE ROLLING COVER.
USE OF THESE WILL VOID THE WARRANTY.
See the Cover Use & Maintenance page for proper care.
Parts check list
Parts check list for rail box
for large box
Instruction packet
Cover rolled into canister-spiral assembly
Driver Side Rail
Front cover for canister
Passenger Side Rail
Keys
Clamp Box
Drain tube kit
Retractable Cover
Installation Instructions, Product Use & Care, Warranty
Spiral Canister
Front Cover
Mounting Screws
(10-24 x 3/4")
Rubber Washers (2)
Drain Tubes (2)
Plug Seals (2)
Passenger Side Rail
NOTE: RH (passenger side) Rail is designated
by a green sticker
Clamps
(6x for 8' beds)
Clamp Box
Clamps(4) 6 for 8" bed
Front Cover Mounting Screws (2)
Canister Mounting Screws (4)
Allen Wrenches- 1/8" and 6mm
Driver Side Rail
6mm Allen
Wrench
Drain
Rubber
Tubes
Washers
Plug
Seals
Tools Required
#2 Philips Screwdriver
9/16" Wrench
(ratchet preferred)
Pliers or locking pliers
IR-FLS-06
1/8"Allen
Wrench
Pg. 1