Washing Supply Connection - Angelo Po FX 61 G3 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

WASHING SUPPLY CONNECTION

To carry out this operation, proceed as follows.
1 – Connect the red pipe (A) to the pipe (B) and fit the
cone (C) into the cleaner tank (D).
2 – Connect the blue pipe (E) to the pipe (B) and fit
the cone (C) into the sanitizing cleaner tank (F).
Use the cleaner and sanitizing supplied by the oven
manufacturer for the best results.
The chemical composition of the products referred to
above is as follows:
Cleaner: caustic soda, concentration less than 20%.
Sanitizing cleaner: containing citrates and organic
sequestering agents, less than 15%.
Important
The use of products with different compositions
may damage the system and the oven walls, and
any residues deposited may contaminate foods.
CONNECTING THE BURNT GAS EXHAUST VENT
Important
Make the connection in compliance with the relevant legal requirements, using
appropriate and recommended materials.
Important
The maximum exhaust gas temperature at the
outlet is about 400 °C.
Connecting to a fan extractor hood
IT
Position the appliance underneath the hood (C) as
shown in the diagram.
GB
Important
DE
The gas supply tap must open automatically
when the fan of the extraction system is switched
FR
on.
ES
English
B
C
C
min
0,3m
- 58 -
A
E
F
D
IDM-39617702700.tif
IDM-39619300700.tif
Use and installation manual

Publicité

Table des Matières
loading

Table des Matières