Angelo Po FX 61 G3 Manuel D'utilisation page 118

Alarm Fault
Electrical component compart-
E10
ment has overheated
E11
Electronic circuit board diag-
E13
nostics tripped
E14
The humidity probe has failed or
E19
is not properly connected
E20 Setup error
The washing cycle has been in-
E21 terrupted because there is no
cleaner
The washing cycle has been in-
E22 terrupted because there is no
sanitizing cleaner
The washing cycle has been in-
E23 terrupted during the final saniti-
zation stage
E24 Automatic cleaning system fail-
E26 ure
System filling procedure not
E25
completed
E27 Failure test gas
E28 Valve has failed to close/open.
English
Remedy
The oven solves the problem on
its own
Inform the after-sales service
Inform the after-sales service
Inform the after-sales service
Check the pipe position and the
level of cleaner in the tank; top
up if necessary and restart the
washing cycle.
If it is not possible to complete
the cleaning operation, perform
an emergency rinse or rinse the
cooking chamber by hand
Check the pipe position and the
level of sanitizing cleaner in the
tank; top up if necessary and re-
start the washing cycle
If it is not possible to complete
the cleaning operation, perform
an emergency rinse or rinse the
cooking chamber by hand
Press the reset button and rinse
the cooking chamber thorough-
ly by hand.
Operate the oven in convection
mode to dry the cooking cham-
ber.
Check that no residues of clean-
ing products have been left in-
side the cooking chamber.
Rinse the cooking chamber by
hand.
Check the position of the pipe
and the level of the sanitizer in
the container; if necessary, top
it up and re-launch the automat-
ic cleaning cycle.
Inform the after-sales service
Press the "Reset" button
- 51 -
Notes
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
If the problem persists, call
the after-sales service
If the problem persists, call
the after-sales service
If the problem persists, call
the after-sales service
If the problem persists, call
the after-sales service
The oven's functions are ena-
bled so cooking cycles can be
carried out
If the problem persists, call
the after-sales service
The oven's functions are ena-
bled so cooking cycles can be
carried out
Inform the after-sales service
Use and installation manual
IT
GB
DE
FR
ES