Publicité
Les langues disponibles
Les langues disponibles
Hydraulic system:
- hydraulic oil SEA OX SUPER; 1.2 Lt.
- developing torque 0.76 daN/bar
- output shaft speeds and working times
Pump (l./ min.)
0.5
Speed (rpm)
6°.19
Time (s)
32.4
Rotations under 200° will proportionally reduce the times.
Weight: 12 Kg. with oil
Protection: IP 55
MODEL CHOICE
EN 12453 and EN 12445 standard advises to select the correct model for the door size.
See table below:
Opening width (m.)
Pump capacity l./min.
The selection of the correct unit depends on the size and weight of the door, and also on the resistance incurred during the
movement. The technical data will assist you in this choice.
Experience shows that one unit is suitable for doors up to 3.5 m. wide or 2.5 m. high.
Two units are required for larger doors.
*The above mentioned values are indicative.
GENERAL WORKING
The Scuti is connected to the electronic unit that controls open and close run times of the operator, safety and signalling
equipment. It can be connected with electric lock and it is possible to set the light on while opening and closing the gate. The
manual release can be achieved by one anti-clockwise turn of the release knob. To restore the unit turn clockwise until the
stop. It is possible to add an external key release device opposite to the release knob. It is fixed to the unit by two screws. Make
sure that the device is correctly orientated and fix it with the release knob in the closing position; for this purpose turn the lock
cylinder until the inside bar correctly meets the block cover; fix the cylinder with the dowel provided. Models without hydraulic
lock are provided with emergency release and with the possibility to add an external release device.
INSTALLATION
The unit must be installed using the fixing accessories provided, with reference to Fig. 2.
Fig. 2
The installation of the unit varies according to the type of door that is being automated.
Cod. 67410030
All manuals and user guides at all-guides.com
SEA S.r.l. Zona Ind.le S. Atto Teramo Italia
Sito Internet:
E-mail: seacom@seateam.com (Uff. Commerciale)
0.75
9°.28
21.6
3-4
>4
0,75
0,5
http://www.seateam.com
seatec@seateam.com (Uff. Tecnico)
1) Longheroni da saldare al telo o fissare con viti su
biscotto presaldato sul telo;
2) bracci telescopici;
3) semiassi completi di terminali scanalati da
4) introdurre nell'albero cavo dell'attuatore;
5) supporto di cerniera per braccio telescopico;
6) perno per cerniera;
7) supporto da saldare al telo;
8) coppiglia di fermo.
Rev. 01 del 05/1999
Publicité
