CAB SUBWAY SB.25 AC Mode D'emploi page 11

SUBWAY
Manufacturer's name: Automatismi CAB Srl
Address: Via della Tecnica, 10 (z.i.) - 36010 Velo d'Astico (VI) - Italia
Telephone: +39 0445 741215 Email address: info@automatismicab.com
Person authorised to draft the technical documentation: Automatismi CAB Srl
Product type: UNDERGROUD OIL-HYDRAULIC AUTOMATION
Model/type: SUBWAY
Accessories: N/A
The undersigned Luigi Benincà, as the Legal Officer, declares under his liability that the aforementioned product complies with the
provisions established by the following directives:
Directive 2014/30/UE OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 26 February 2014, on the harmonisation
of the laws of Member States relating to electromagnetic compatibility (EMCD), according to the following harmonised regulations:
EN 61000-6-2:2005, EN 61000-6-3:2007 + A1:2011.
Directive 2011/65/EU of the European Parliament and Council, dated 8 June 2011, on the restricted use of certain hazardous
substances in electrical and electronic devices (RoHS), according to the following standards:
EN 50581:2012
Directive 2014/35/UE of the european parliament and of the council of 26 February 2014, on the harmonisation of the laws of
Member States relating to electrical equipment designed for use with certain voltage limits (LVD), according to the following
harmonised regulations:
EN 60335-1:2012 + A11:2014; EN 60335-2-103:2015.
Benincà Luigi, Legal Officer.
Velo d'Astico, 11/01/2017.
The product shall not be used for purposes or in ways
other than those for which the product is intended for and
as described in this manual. Incorrect uses can damage
the product and cause injuries and damages.
The company shall not be deemed responsible for the
non-compliance with a good manufacture technique of
gates as well as for any deformation, which might occur
during use.
Keep this manual for further use.
Qualified personnel, in compliance with regulations in force,
shall install the system.
Packaging must be kept out of reach of children, as it can
be hazardous. For disposal, packaging must be divided
the various types of waste (e.g. carton board, polystyrene)
in compliance with regulations in force.
The installer must supply all information on the automatic,
manual and emergency operation of the automatic system
and supply the end user with instructions for use.
UE Declaration of Conformity (DoC)
Rev: 0
WARNING
•
An omnipolar switch/section switch with remote
contact opening equal to, or higher than 3mm
must be provided on the power supply mains..
Make sure that before wiring an adequate differential
switch and an overcurrent protection is provided.
Pursuant to safety regulations in force, some types of
installation require that the gate connection be earthed.
During installation, maintenance and repair, cut off power
supply before accessing to live parts.
Descriptions and figures in this manual are not binding.
While leaving the essential characteristics of the product
unchanged, the manufacturer reserves the right to modify
the same under the technical, design or commercial point
of view without necessarily update this manual.
File name: SUBWAY_ENG_rev0.pdf
ENG
11