Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
22 progress
is in setting mode. Refer to 'SETTING
AND STARTING A PROGRAMME'.
• If the salt indicator is on, fill the salt
container.
3. Make sure that there is rinse aid in the
rinse aid dispenser.
Using the detergent
D
A B
30
20
A
B
D
3
0
2 0
Setting and starting a programme
Setting mode
The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when, af-
ter the activation, all the programme indica-
tors come on.
If the control panel shows other conditions,
press and hold function buttons (B) and (C)
at the same time until the appliance is in
setting mode.
Starting a programme without delay
start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode.
3. Press the button of the programme you
want to set.
C
A
-
+
C
4. Load the baskets.
5. Add the detergent.
6. Set and start the correct programme for
the type of load and the degree of soil.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
• The related programme indicator
stays on.
• All the other programme indicators go
off.
4. Close the appliance door. The pro-
gramme starts.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button again and again
until the indicator of the number of
hours you want to set comes on. You
can set 3, 6 or 9 hours.
• The delay indicator comes on.
3. Close the appliance door. The count-
down starts. When the countdown is
completed, the programme starts.
Publicité
Table des Matières
