Publicité
Les langues disponibles
Les langues disponibles
www.evolutionpowertools.com
NOTE: By loosening the thumb screws the Repeat Stop can
be adjusted to the required distance from the saw blade for
repetitive cutting operations etc. The Repeat Stop can be fitted
to either of the Workpiece Support Bars but normally will be
positioned to the Right Hand side of the blade.
MAINTENANCE
NOTE: Any maintenance must be carried out with the
machine switched off and disconnected from the mains/
battery power supply.
Check that all safety features and guards are operating correctly on
a regular basis. Only use this machine if all guards/safety features
are fully operational.
All motor bearings in this machine are lubricated for life. No further
lubrication is required.
Use a clean, slightly damp cloth to clean the plastic parts of the
machine. Do not use solvents or similar products which could
damage the plastic parts.
WARNING: Do not attempt to clean by inserting pointed objects
through openings in the machines casings etc.
The machines air vents should be cleaned using compressed
dry air.
Excessive sparking may indicate the presence of dirt in the motor
or worn out carbon brushes located in the motor housing. If this is
suspected, have the carbon brushes replaced.
Table Insert
A two piece table insert is fitted to this machine.
If either side is damaged or worn, both parts must be replaced.
Replacement inserts (sold in handed pairs) are available from
your supplier or Evolution Power Tools.
34
Publicité
