Publicité
Les langues disponibles
Les langues disponibles
www.evolutionpowertools.com
EXTRACTION PORT ADAPTOR TUBE
Use the Adaptor Tube to connect the extraction port of the
machine to suitable commercial workshop vacum extraction
equipment (not supplied) which have Ø30mm internal bore
hoses or inlet ports.
WORKPIECE SUPPORT BARS
Workpiece Support Bars can be fitted to either or both sides of
the machines base as required.
• Right Hand side. Loosen the support retaining screw located in
the top front of the machines base.
• Insert the workpiece supports bars into the retaining holes in
the base. Push fully home to ensure positive location.
NOTE: Approximately 75mm (2-19/20") of the, (Fig. 44a)
Workpiece Support Bar should slide into the base to provide
positive location.
• Tighten the retaining screw. (Fig. 44b)
• Repeat the above for the Left Hand side.
To remove a Workpiece Support Bar, simply loosen the relevant
retaining screw and slide the Workpiece Support Bar from the
machine. Store safely for future use.
THE REPEAT STOP
(Fig. 45)
The use of the Repeat Stop can greatly aid the operator when
conducting repetitive cutting operations. When many pieces
of material all cut to the same length are required, use of the
Repeat Stop can assist accuracy and efficiency.
Fitting the Repeat Stop
• Loosen the Repeat Stop thumb screws sufficiently to allow
the arms of the Workpiece Support Bar to slide through the
holes in the Repeat Stop.
• Position the Repeat Stop approximately half way along the
Workpiece Support Bar, and tighten the thumb screws to
minimize any movement.
• Attach the Workpiece Support Bar to the machine base as
previously detailed.
(Fig. 44a & 44b)
33
Fig. 44a
Fig. 44b
Fig. 45
EN
ES
FR
Publicité
