Publicité
Les langues disponibles
Les langues disponibles
www.evolutionpowertools.com
NOTE: The following WARNING labels may be found on this
machine:
LASER RADIATION DO NOT STARE INTO THE
BEAM
CLASS 2 LASER PRODUCT
CLASS 2 LASER PRODUCT LASER RADIATION AVOID
DIRECT EYE CONTACT LASER SAFETY
The Laser guide line used in this product uses a class II Laser
with a maximum power output of 1.5mW at a wave length of
between 635 and 670nm. These lasers do not normally present
an optical hazard, although staring at the beam may cause
temporary flash blindness.
WARNING: Do not stare directly at the Laser beam. The laser
must be used and maintained as detailed in this manual. Never
intentionally aim the laser beam at any person and prevent it
from being directed towards the eye, or an object other than
the workpiece. Always ensure that the laser beam is directed at
the workpiece only when it is located on the mitre saw table.
Never direct the laser beam onto any bright, shiny reflective
surface, as the laser beam could be reflected back towards the
operator. Do not change the laser unit for any other type.
Do not tamper with the laser unit. Only touch the unit when
making adjustments. Repairs to the laser shall only be carried
out by an authorised service centre.
THE LASER GUIDE LINE
The projected laser guide line shows the path of the blade
during a cut.
To use the laser guide for a known angle (e.g. 45
• Mark the cut required on the workpiece using a pencil etc.
• Set the saw to the cutting angle required (45
position using the mitre locking handle and/or the positive
stop locking lever.
• Switch on the laser beam.
• Position the workpiece on the rotary table and against the fence.
• Slide the workpiece into position until the pencil line on the
workpiece and the projected laser line exactly match.
• Clamp the workpiece into position using the hold down clamp.
• Proceed to make the cut.
):
0
) and lock into
0
19
EN
ES
FR
Publicité
