Publicité
Les langues disponibles
Les langues disponibles
Fig. 22
Fig. 23
Fig. 24
DO NOT OVER-REACH
Keep good footing and balance. Stand to one side so that your
face and body are out of line of a possible kickback.
FREEHAND CUTTING IS A MAJOR CAUSE OF ACCIDENTS
AND MUST NOT BE ATTEMPTED.
• Ensure that the workpiece is always firmly resting against the
fence, and where practical is clamped with the Hold Down
Clamp to the table.
• The saw table should be clean and free from any sawdust etc.
before the workpiece is clamped into position.
• Ensure that the 'cut-off' material is free to move sideways
away from the blade when the cut is completed. Ensure that
the 'cut-off' piece cannot become 'jammed' in any other part
of the machine.
• Do not use this saw to cut small pieces. If the workpiece
being cut would cause your hand or fingers to be within
150mm (5-9/10") of the sawblade, the workpiece is too small.
THE MOTOR ON/OFF SWITCH (Fig. 22)
The ON / OFF Motor Trigger Switch is a non-latching type. It
is the upper of the two switches that are positioned inside the
Cutting HANDLE.
• Press the switch to start the motor.
• Release the switch to turn off the motor.
CHOP CUTTING
This type of cut is used mainly for cutting small or narrow
section material. The Cutting Head is gently pushed down to cut
through the workpiece.
The Sliding Carriage should be locked in its rearmost
position. (Fig. 23)
• Slide the Cutting Head to the rear as far as it will go.
• Tighten the slide lock screw. (Fig. 24)
• Place the workpiece on the table and against the fence and
secure with clamp(s) as appropriate.
• Grasp the saw handle.
• Turn the motor on and allow the saw blade to reach full speed.
• Press the lower guard locking trigger to release the Cutting Head.
26
www.evolutionpowertools.com
Publicité
