Sonoro PLATINUM SO-2000 Mode D'emploi page 43

9. Adjust the overhang
• Move the cartridge to adjust the overhang in
such a way the stylus tip is at 52.8mm from
the headshell mounting end.
52.8mm
• The cartridge should be parallel on the
headshell when viewed from the top.
• The cartridge should also not tilt when viewed
from the side.
• After the adjustments are complete, tighten
the screws securely.
• Attach the headshell to the tonearm.
10. Adjust the tonearm height
• Place a record on the turntable.
• Place the stylus tip on a record and check that
the tonearm is parallel to the record.
• Insert the 2mm hex wrench (not included) into
the height adjustment screw hole and turn it
counterclockwise to unlock the tonearm base.
© sonoro audio GmbH 2021
High adjustment
Screw hole
Tonearm base
• Hold the tonearm base, and adjust the height
to make the tonearm level.
• Turn the hex wrench clockwise to lock the
tonearm base.
• Adjust the tonearm balance and tracking
force.
11. Replacing the drive belt
The drive belt will wear or may even break over
time. In such case, replace it with a new one. To
obtain a spare drive belt, contact your dealer or
the customer support.
• Turn off your turntable the connected audio
device and unplug the AC adapter from the
AC inlet.
• Remove the mat of the platter.
• Turn the platter to the position where you can
see the motor pulley through the circle hole
on the platter.
• Unhook the drive belt from the motor pulley.
Motor pulley
GB
Pedestal
Drive belt
43