Sonoro PLATINUM SO-2000 Mode D'emploi page 42

• Use a small brush (not included) if the stylus
tip is considerably dirty. Clean the stylus tip by
moving the brush from the rear to the front of
the stylus tip.
7. Replacing the stylus
If the tip of the stylus become worn, not only will
it worsen the sound quality, it could also
damage records. After about 1000 hours of
playback time, replace the stylus with one that
we specify.
• Please use Ortofon 2M RED / 2M Blue
replacement stylus.
• Follow the replacement instructions in the
manual of the replacement stylus.
To remove old stylus
• Keep attaching the stylus protective cover on
the cartridge.
• Release the headshell from the tonearm.
• Hold the cartridge in one hand, grasp the
plastic stylus housing with thumb and
forefinger, and pull away from the cartridge.
Installing a new replacement stylus
• To install replacement stylus, insert the new
stylus assembly into the cartridge.
42
• The stylus assembly should be fully seated
into the cartridge.
• Mount the headshell onto the tonearm.
8. Replacing the cartridge
Note:
• The cartridge installed in this unit is
equivalent to Ortofon 2M Red.
• If you use another cartridge than Ortofon 2M
Red, you might need to adjust overhang and
weight, as well the height of your tonearm. If
in doubt, please ask your dealer.
• Keep attaching the stylus protective cover on
the cartridge.
• First remove the headshell from the tonearm.
• Use a non-metallic slotted screwdriver to
remove the installation screws, washers and,
and then remove the cartridge from the
headshell.
• Refer to the user manual for new cartridge for
mounting instruction and connecting to the
shell leads.
• The signals and colors of the shell leads are
shown below.
Signal
Left channel +
Left channel -
Right channel +
Right channel -
• Use a non-metallic slotted screwdriver to
tighten the screws in both places, and then
adjust the overhang.
© sonoro audio GmbH 2021
Screw
Plastic washer
Cartridge
Shell leads
Color
White
Blue
Red
Green