Playing A Record - Sonoro PLATINUM SO-2000 Mode D'emploi

• If your audio system has no phono input, use
a free Aux-in RCA input.
• The white plug is for the left channel, the red
plug for the right channel.
2. Setting pre-amplifier selector switch
Switch the pre-amplifier switch on the back side
of PLATINUM according to the features of your
audio system / amplifier PLATINUM is
connected to:
• Set the switch to OFF position.
If your audio system / amplifier has a PHONO
input jack, PLATINUM can be connected
directly to it, bypassing it's built-in pre-
amplifier by switching it OFF.
© sonoro audio GmbH 2021
U S B
• Set the switch to ON position.
If your audio system / amplifier has no phono
input, you can use the build-in pre-amplifier
of PLATINUM by switching it ON.
3. Connecting the AC adapter
• After completing all other connections,
connect the included AC adapter to the DC
input socket.
• Insert the power supply into an AC inlet
socket.
5.

Playing a record

Note:
• Before you play a record, turn down the audio
device's volume. The loud, crackling noise
made by the tone arm descending and the
stylus coming into contact with the record
could damage the speakers or audio device.
Wait until the stylus has completely
descended, and then adjust the volume.
• Even new records may produce a crackling
noise when you play them. Please note that
this noise is a characteristic of playing records.
• Place only one record on the platter at a time.
• Close the turntable cover during record
playback to avoid dust.
• Do not stop turntable rotation during
playback.
• During record playback, feedback could
occur if the volume is too loud. If this
happens, lower the volume of the amplifier.
GB
37