When Playback Finishes; Connecting With Bluetooth Device - Sonoro PLATINUM SO-2000 Mode D'emploi

8. Holding the finger lift of the headshell,
move the tone arm over the edges of the
record or the track where you want to
start playback.
9. Lower the tonearm lifter.
• Lower the tone arm slowly until the stylus
touches the record and playback begins.
10. Gently close the dust cover.
6.

When playback finishes

Note:
• PLATINUM is a manual record player. It will
not automatically stop!
• Please always lift the tonearm at the end of a
record to prevent damage of stylus and
record.
1. Raise the tonearm lifter.
2.
Return the tonearm
• Holding the finger lift of the headshell, move
the tone arm toward its original position.
• Lock the tonearm rest clamp.
3. Rotate the Speed / STOP rotatory switch
knob to STOP position.
• When the turntable stops, the platter will not
rotate.
• Press the ON/OFF button on the back of the
turntable to turn it off if no longer to use.
© sonoro audio GmbH 2021
7. Connecting with
Bluetooth device
PLATINUM can connect to Bluetooth-enabled
devices (e.g. Bluetooth speakers and Bluetooth
headphone).
Note:
• Operating distance is within a range of
approximately 10 meters (30 feet).
• Refer to the operation manual of the
Bluetooth devices for information how to use
it.
• Pairing might take some time depending on
the connected device.
• If there are playback devices, which support
Bluetooth wireless technology nearby, that
have the Bluetooth function enabled, but
some of them are not the devices with which
you want to pair, disable their Bluetooth
function and try pairing again.
• Do not connect to Bluetooth speakers or
headphones for which you cannot adjust the
volume. Audio tracks may be played at very
loud volumes.
• You cannot pair the turntable with
smartphones, TVs, or computers, etc.
1. First time pairing Bluetooth device
• Press the BT button on the turntable to start
Bluetooth connection mode. The indicator
will become blue and blink slowly.
• Press the BT button again for at least two
seconds to start pairing mode. The blue
indicator will flash rapidly.
• After turntable enters pairing mode, put the
Bluetooth device into paring mode.
• Pairing is automatically done. When the
turntable and the Bluetooth device are
connected, the indicator will stay lit without
flashing.
Bluetooth indicator /
Pairing button
39
GB