Subaru H001SXC300 Instructions D'installation page 11

SYSTEM REGISTRATION
10
ENSURE THE SOFTWARE VERSION HAS BEEN UPDATED TO THE LATEST REVISION
BEFORE ATTEMPTING SYSTEM REGISTRATION.
NOTE: Once the Ignition is turned ON, the system will exit System Registration after
2 minutes.
DST-i SETUP
Plug the DST-i
diagnostic plug
into the vehicle’s
diagnostic connector
REGISTRATION
1. PRESS IMMOBILIZER ETC. REGISTRATION,
PRESS IMMOBILIZER REGISTRATION AND
PRESS SELECT
PRESS
3. PRESS G TYPE FOR KEY START MODELS
AND PRESS CONFIRMED
PART NUMBER ISSUE
H001SXC300
PRESS
PRESS
PRESS
PRESS
DATE
- 24 May 2022
Plug the DST-i
USB plug into a
Network-Enabled
laptop
2. PRESS ASCENT AND PRESS SELECT
Insert an ignition key
into the ignition
cylinder and turn to
the ON position
4. ENSURE THE IGNITION IS TURNED ON AND
PRESS OK
WAIT FOR LAPTOP TO
ESTABLISH CONNECTION
SUBARU OF AMERICA
Select/Open the SSM4
software on the
Network-Enabled
laptop
PRESS
PRESS
PRESS
11 OF 14