Subaru H001SXC300 Instructions D'installation page 6

5
REMOTE ENGINE START WIRE HARNESS CONNECTIONS / ROUTING, continued
5. Plug the remote engine start harness 4-pin and 2-pin
connectors into the corresponding pre-fit connectors.
(FIGURE N) Using one (1) of the supplied 39cm tie wraps,
secure the remote engine start harness to the vehicle wiring
harness at the white tape ring on the remote engine start
harness. Trim o the excess tie wrap. Tuck the 4-pin and
2-pin connectors behind the vehicle wiring harness.
(FIGURE N)
6. Plug the remote engine start harness 6-pin connector into the
corresponding pre- t ignition connector. (FIGURE O)
7. Using three (3) of the supplied 39cm tie wraps, secure the
remote engine start harness to the vehicle wiring harness.
Working from right to left; attach one (1) tie wrap around the
6-pin pre- t ignition connection, one (1) tie wrap around the
remote engine start fuse holders and one (1) tie wrap at the
white tape ring on the remote engine start harness. Trim o
the excess tie wraps. Exercise the tilt and telescopic steering
wheel after securing the tie wraps to ensure the wire harness
is not stressed. (FIGURE P)
PART NUMBER
ISSUE
H001SXC300
DATE
-
24 May 2022
Back of
Fuse Box
FIGURE N
FIGURE O
FIGURE P
SUBARU OF AMERICA
Remote Engine Start
Fuse Holders
Pre- t Ignition
Connection
Remote Engine Start
Fuse Holders
6 OF 14