Subaru H001SXC300 Instructions D'installation page 3

4
VEHICLE PREPARATION, continued
5. Using a 10mm socket/ratchet/extension, remove the two
(2) 10mm nuts securing the driver’s side lower airbag/
knee bolster. (FIGURE E)
6. Remove the lower airbag/knee bolster. Using a pick tool,
disengage the yellow connector lock by lifting upward.
(FIGURE F)
Using a panel removal tool, carefully lift upward to
unplug the electrical connector and place the airbag/
knee bolster panel in a safe area.
7. Open the glove box and press inward on the sides of
the glove box to disengage the retaining tabs from the
glove box inner cover. Disconnect the strut from the
glove box. (FIGURE G)
PART NUMBER ISSUE
H001SXC300
DATE
- 24 May 2022
FIGURE E
FIGURE F
FIGURE G
SUBARU OF AMERICA
3 OF 14