Subaru H001SXC300 Instructions D'installation page 5

5
REMOTE ENGINE START WIRE HARNESS CONNECTIONS / ROUTING
1. Locate and release the vehicle’s 6-pin pre- t ignition connector
secured to the vehicle’s wire harness with breakaway tape
near the base of the steering column. (FIGURE K)
2. Locate and release the vehicle’s 4-pin and 2-pin pre-fit
connectors secured to the vehicle’s wire harness with
breakaway tape near the upper driver’s side kick panel area.
(FIGURE L)
3. When the vehicle’s 4-pin and 2-pin pre- t connectors are free
from the breakaway tape, unplug and discard the 2-pin mating
connector/wire jumper. (This is used for the power window
interrupt circuit).
4. Route the remote engine start harness 4-pin and 2-pin
connectors over the steering column toward the driver’s side
kick panel area. (FIGURE M)
PART NUMBER ISSUE
H001SXC300
DATE
- 24 May 2022
FIGURE K
FIGURE L
FIGURE M
SUBARU OF AMERICA
Back of
Fuse Box
5 OF 14