Subaru H001SXC300 Instructions D'installation page 8

5
REMOTE ENGINE START WIRE HARNESS CONNECTIONS / ROUTING, continued
11. Using alcohol, clean the air duct surface to the right of
the center console, as shown. Remove the release liner
from one (1) of the supplied wire harness clips. Apply
to the air duct above the hose port and press  rmly in
place for at least ten (10) seconds. Secure the remote
engine start harness to the wire harness clip at the white
tape ring. (FIGURE T)
NOTE: Ensure the opening of the wire harness clip
faces upward.
6
REMOTE ENGINE START ECU MOUNTING
1. Locate the glove box inner cover and carefully pull back
the insulation pad from the top and back areas, as shown.
Using alcohol, clean the top and back of the glove box
inner cover, as shown. (FIGURE U)
NOTE: Ensure the glove box inner cover is
completely dry.
2. Remove the release liners from two (2) of the supplied
wire harness clips. Apply to the back of the glove box
inner cover and press  rmly in place for at least ten (10)
seconds. (FIGURE V)
NOTE: Ensure the opening of the left wire harness
clip faces upward and the opening of the right wire
harness clip faces the passenger door when the
glove box inner cover is reassembled.
PART NUMBER
ISSUE
H001SXC300
DATE
-
24 May 2022
FIGURE T
Insulation
Clean with
Alcohol
FIGURE U
Left Clip
FIGURE V
SUBARU OF AMERICA
Hose Port
Right Clip
8 OF 14