Subaru H001SXC300 Instructions D'installation page 7

5
REMOTE ENGINE START WIRE HARNESS CONNECTIONS / ROUTING, continued
8. Using two (2) of the supplied 39cm tie wraps,
secure the remote engine start harness to the
vehicle wiring harness. Attach one (1) tie wrap to
the right of the factory tie wrap at the white tape ring
on the remote engine start harness. Attach one (1)
tie wrap to the right of the steering column, above
the air duct at the white tape ring on the remote
engine start harness. Trim o the excess tie wraps.
(FIGURE Q)
9. Using alcohol, clean the air duct surface to the
left of the center console, as shown. Remove the
release liners from two (2) of the supplied wire
harness clips. Apply to the air duct and press  rmly
in place for at least ten (10) seconds. (FIGURE R)
NOTE: Ensure the openings of the wire harness
clips face upward.
10. Route the remote engine start harness toward the
passenger’s side of the vehicle behind the center
console area. Secure the remote engine start
harness to the wire harness clips at the white tape
rings. (FIGURE S)
PART NUMBER ISSUE
H001SXC300
DATE
- 24 May 2022
Factory
Tie Wrap
Steering
Column
FIGURE Q
FIGURE R
FIGURE S
SUBARU OF AMERICA
Hose Port
Accelerator
Pedal
Hose Port
Accelerator
Pedal
7 OF 14