Machine Long Inactivity; First Period Of Use; Maintenance; Scheduled Maintenance Table - Nilfisk Advance Clarke CR 28 Boost Manuel D'utilisation

MACHINE LONG INACTIVITY

1. If the machine is not going to be used for more than 30 days, proceed as follows:
2. Perform the procedures shown in After Using the Machine paragraph.
3. Before disconnecting the battery red connector (74) perform the following procedures:
• Open the covers (51 and 58) and check that the tanks (60 and 61) are empty, otherwise drain them through the drain hose
(10) and the tap (24).
• Close the covers (51 and 58).
• Carefully lift the tank assembly (71).

FIRST PERIOD OF USE

After the fi rst 8 hours, check the machine fastening and connecting parts for proper tightening. Check the visible parts for integrity
and leakage.

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the batteries disconnected.
Moreover, carefully read all the instructions in the Safety paragraph.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorized Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
NOTE
For other maintenance procedures contained in the Scheduled Maintenance Table or for extraordinary maintenance
procedures see the specifi c Service Manual that can be consulted at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Squeegee cleaning
Brush cleaning
Cleaning of Tank and Vacuum screen and Float
Battery charging
Squeegee blade check and replacement
Side skirt check
Solution fi lter cleaning
Battery (WET) fl uid level check
Screw and nut tightening check
Squeegee cable sliding shoe lubrication
Electromagnetic brake effi ciency check
®
BOOST deck motor carbon brush check or replacement
Vacuum system motor carbon brush check or replacement
Drive system motor carbon brush check or replacement
(1) And after the fi rst 8 working hours.
(2) This maintenance procedure must be performed by Clarke authorized Service Center.

MACHINE WORKING HOUR CHECK

1. Insert the ignition key (42) and turn it to "I".
2. In the fi rst 5 seconds of machine operation, the display (38) shows the total number of working hours (scrubbing/drying)
performed by the machine.
Turn the ignition key (42) to "0".
Daily, after using
Weekly
the machine
Operator's Manual - CR 28 BOOST®
ENGLISH
Every six
Yearly
months
(1)
(2)
(2)
(2)
(2)
(2)
17