Stiga MCS 470 Li D48 Serie Manuel D'utilisation page 133

13. MAINTENANCE TABLE
Intervention
MACHINE
Check all fasteners
Safety checks/check controls
Check the guard and the
side discharge chute
Check the cutting means
Check the battery
charge status
Recharge the battery
General cleaning
and inspection
Checking for any damage to
the machine. If necessary,
contact the authorised
service centre.
Cleaning the air filter
Cleaning the transmission
Replacing the cutting means
Drive adjustment
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or a specialised Authorised Service Centre
*** Operation to be performed at the first signs of any malfunction
14. PROBLEM IDENTIFICATION
If problems persist after having performed the above operations, contact your dealer.
PROBLEM
1. The engine does not
start when using the
switch (type "I" handle).
2. The display does not
start when pressing
the power button (type
"II"/"III" handle - Ad-
vanced Series).
Frequency
Before each use
Before each use
Before each use
Before each use
Before each use
After each use
After each use
After each use
Once a month
1-2 times a year
-
***
PROBABLE CAUSE
Safety key is not inserted or
is inserted incorrectly.
Battery is not inserted or is
inserted incorrectly.
Low battery.
The engine does not start immediately.
The thermal protection has tripped
due to overheating of the motor.
Safety key is not inserted or
is inserted incorrectly.
Battery is not inserted or is
inserted incorrectly.
Insert the key (par. 6.3).
Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.4).
Check the battery status and recharge
if necessary (par. 7.2.3).
Keep the switch control pressed
for 1-3 seconds (par. 5.2).
Wait for at least 5 minutes and
restart the machine.
Insert the key (par. 6.3).
Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.4).
EN - 13
Notes
par. 7.4
par. 6.2
par. 6.2.1
par. 6.2.1
*
par. 7.2.3 *
par. 7.3
-
par. 7.6
par. 7.5
par. 8.1 ***
**
SOLUTION