Philips AquaTrio FC7070 Mode D'emploi page 28

Problem
I cannot tilt
the appliance
backwards
without the
nozzle coming off
the floor.
The appliance
does not take
up water when
I flush the
mopping nozzle.
The tank full/
tank empty light
starts flashing
and the appliance
switches off
while flushing the
mopping nozzle.
The tank full/tank
empty light lights
up continuously
and the appliance
switches off
while flushing the
mopping nozzle.
I cannot move
the appliance
forwards or
backwards.
I cannot find the
vacuum cleaning
function.
Note: If the above solutions did not solve your problem, please visit www.philips.com/support or
contact the Philips Consumer Care Centre in your country.
28
Possible cause
The appliance is
locked in parking
position.
You poured too
much water into
the flushing tray or
you poured it in too
fast. This causes the
mopping brushes
to become too wet.
When the brushes
are too wet, the
active protection
system is activated.
The mopping
brushes stopped
rotating because they
encountered too
heavy resistance.
The clean water tank
is empty.
The dirty water tank
is full.
One or more wheels
may be blocked by a
small object.
There is no separate
vacuum cleaning
function.
solution
Press the parking position release button with your
foot to unlock the appliance from parking position
(see chapter 'Using your AquaTrio', section 'Pausing
during use').
switch off the appliance, put the appliance upright
in parking position ('click'), and pull the plug out of
the wall socket. Remove the mopping brushes from
the mopping nozzle and remove excess water from
the mopping brushes by squeezing them over a sink
(see chapter 'Cleaning and maintenance', section
'Cleaning the mopping nozzle'). Then you can reinsert
the mopping brushes, reinsert the mopping brush
cover, close the mopping nozzle lid and switch
on the appliance again (see chapter 'Cleaning and
maintenance', section 'Reassembling the mopping
nozzle'). If this does not work, let the mopping
brushes dry (see chapter 'Cleaning and maintenance',
section 'Cleaning the mopping nozzle').
Refill the clean water tank (see chapter 'Preparing for
use', section 'Filling the clean water tank') and start
the flushing procedure again (see chapter 'Cleaning
and maintenance', section 'Flushing your AquaTrio').
Empty the dirty water tank (see chapter 'Using your
AquaTrio', section 'Emptying the dirty water tank')
and start the flushing procedure again (see chapter
'Cleaning and maintenance', section 'Flushing your
AquaTrio').
switch off and unplug the appliance and then put it
on its side. Make sure the dirty water tank is empty
when you put the appliance on its side, otherwise
wastewater may leak out of the dirty water tank.
Check what is blocking the wheel(s). Remove
any object that could block the wheel(s). Put the
appliance upright again and resume cleaning.
When you switch on the appliance, the mopping and
the vacuum cleaning functions work at the same time.