Philips AquaTrio FC7070 Mode D'emploi page 24

Problem
The appliance
does not clean as
well as it used to.
24
Possible cause
The active protection
system may have
been activated for
three reasons: (1) the
appliance picked up
a foreign object, (2)
the mopping brushes
are too wet or (3)
you have moved
the appliance over a
carpet. The mopping
brushes automatically
stopped rotating
because they
encountered too
heavy resistance. The
appliance continues
to make a sound,
but it does not work
properly.
The active protection
system has been
activated because the
brushes are too wet.
The mopping brushes
automatically stopped
rotating because they
encountered too
heavy resistance.
solution
Release the power-on button to switch off the
appliance. Put the appliance upright in parking
position ('click') and pull the plug out of the wall
socket. Open the mopping nozzle lid, remove
the mopping brush cover and remove the object.
Reinsert the mopping brush cover, close the mopping
nozzle lid, put the plug in the wall socket and switch
on the appliance again (see chapter 'Using your
AquaTrio', section 'Active protection system is
activated'). If you find no object, the active protection
system may have been activated because the
mopping brushes are too wet (see next cause and
solution) or because you moved the appliance over
a carpet. Pull the plug out of the wall socket, open
and close the mopping nozzle lid, put the plug in the
wall socket again, switch on the appliance and start
cleaning again.
If the above solutions did not help and the appliance
still does not work, switch on the appliance for at
least 10 seconds. Then open and close the mopping
nozzle lid, switch on the appliance and start cleaning
again.
Release the power-on button to switch off the
appliance. Put the appliance upright in parking
position ('click') and pull the plug out of the wall
socket. Remove the mopping brushes from the
mopping nozzle and remove excess water from the
mopping brushes by squeezing them over a sink (see
chapter 'Cleaning and maintenance', section 'Cleaning
the mopping nozzle'). Then you can reinsert the
mopping brushes, reinsert the mopping brush cover,
close the mopping nozzle lid, put the plug in the wall
socket and switch on the appliance again (see chapter
'Cleaning and maintenance', section 'Reassembling
the mopping nozzle'). If this does not work, let the
mopping brushes dry (see chapter 'Cleaning and
maintenance', section 'Cleaning the mopping nozzle').