Philips AquaTrio FC7070 Mode D'emploi page 27

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Problem
Possible cause
I have just filled
The tank full/tank
the clean water
empty light may flash
tank, but the
a few times when
tank full/tank
you switch on the
empty light keeps
appliance after you
flashing when I
have filled the clean
switch on the
water tank.
appliance.
If the tank full/tank
empty light continues
to flash after filling,
the clean water
tank may not be
assembled properly.
Water drips out
Water leaks from
of the appliance.
the clean water tank
because you have
not put the cap on
the clean water tank
or you have not
fastened this cap
properly.
Water leaks from
the clean water
tank because you
overfilled the clean
water tank.
Water leaks from
the dirty water tank
because you tilted
the upper body too
far backwards or
because you placed
the appliance on
its side. This caused
wastewater to run
out of the dirty water
tank.
I cannot remove
You probably tried
the mopping
to remove them by
brushes.
pulling at the wrong
side.
solution
When you switch on the appliance after you have
filled the clean water tank, the tank full/tank empty
light may flash a few times and the appliance may
switch off automatically. This happens because it takes
a few seconds for the water to reach the mopping
nozzle. Release the power-on button. Then push
the unlock slide forwards and press the power-on
button to switch on the appliance again (see chapter
'Preparing for use', section 'Filling the clean water
tank').
Make sure you place the clean water tank properly
and that the lever is locked (see chapter 'Preparing
for use', section 'Filling the clean water tank').
Remove the clean water tank from the appliance. Put
the cap on the water tank if it was not there or turn
the cap clockwise to fasten it (see chapter 'Preparing
for use', section 'Filling the clean water tank').
Do not fill the clean water tank beyond the MAX
indication. If you do, water may spill from the clean
water tank when you fasten the cap (see chapter
'Preparing for use', section 'Filling the clean water
tank').
Do not tilt the upper body of the appliance too far
backwards, for instance when you clean under a low
table. Do not place the appliance on its side when
there is wastewater in the dirty water tank (see
chapter 'Important', section 'Caution').
grab the lime green grips of the brushes and pull
the brushes up a little. Then you should be able to
slide them off the projection on the other side (see
chapter 'Cleaning and maintenance', section 'Cleaning
the mopping nozzle').
27

Publicité

Table des Matières
loading

Table des Matières