Moving Your Aquatrio; Replacing The Mopping Brushes - Philips AquaTrio FC7070 Mode D'emploi

7.2 Moving your AquaTrio

switch off the appliance, place the appliance
1
upright in parking position ('click') and pull the
plug out of the wall socket.
Wrap the mains cord around the cord
2
storage hook and the lever for the dirty water
tank. Instead, you can also wind up the mains
cord and hang it on the cord storage hook.
You can move the AquaTrio in two ways:
3
•
You can lift and carry the appliance by its
carrying handle.
•
You can tilt the appliance backwards until
it leans on its wheels. Pull the appliance
backwards to move it.
7.2.1 Important to know
• Do not move the AquaTrio over a carpet,
as concentrated wastewater droplets may fall
from the mopping nozzle.
•
Be careful if there is sand on the floor. If you
move the appliance over sand when it is
switched off, its wheels may scratch the floor.
• If you move the appliance across a hard floor
with the mopping nozzle placed on the floor,
the mopping brushes may leave a damp trace
on the floor.
8 Replacing the
mopping brushes
If you want to continue to benefit from your
AquaTrio's cleaning results, make sure you always
use original Philips microfibre mopping brushes
and replace them every six months. If you follow
this advice, your AquaTrio will always provide you
with excellent cleaning results. For replacement
reminders, support, tips and tricks, register your
product online at www.philips.com/welcome
switch off the appliance, place the appliance
1
upright in parking position ('click') and pull the
plug out of the wall socket.
Remove the old mopping brushes from the
2
mopping nozzle one by one (see chapter
'Cleaning and maintenance', section
'Reassembling the mopping nozzle').
Place two new mopping brushes into the
3
mopping nozzle one by one (see chapter
'Cleaning and maintenance', section
'Reassembling the mopping nozzle').
19