Philips AquaTrio FC7070 Mode D'emploi page 26

Problem
The appliance
did not work
properly before
I stored it, but
it now works
properly again.
26
Possible cause
The active protection
system has been
activated because the
brushes are too wet.
The mopping brushes
automatically stopped
rotating because they
encountered a too
heavy resistance.
The mopping nozzle
lid is not closed
properly.The sound
of the appliance
decreases and the
appliance no longer
applies water to the
floor because the
mopping brushes do
not rotate and the
appliance does not
mop up anything.
The active protection
system was activated
because the appliance
picked up a foreign
object other than dirt
or liquid. Then you
stored the appliance
for more than 30
minutes and it reset
itself.
solution
Release the power-on button to switch off the
appliance. Put the appliance upright in parking
position ('click') and pull the plug out of the wall
socket. Remove the mopping brushes from the
mopping nozzle and remove excess water from the
mopping brushes by squeezing them over a sink (see
chapter 'Cleaning and maintenance', section 'Cleaning
the mopping nozzle'). Then you can reinsert the
mopping brushes, reinsert the mopping brush cover,
close the mopping nozzle lid, put the plug in the wall
socket and switch on the appliance again (see chapter
'Cleaning and maintenance', section 'Reassembling
the mopping nozzle'). If this does not work, let the
mopping brushes dry (see chapter 'Cleaning and
maintenance', section 'Cleaning the mopping nozzle').
Make sure the mopping brushes and the mopping
brush cover are assembled correctly. Close the
mopping nozzle lid properly. Make sure you press
the lid until it locks with a click (see chapter 'Cleaning
and maintenance', section 'Reassembling the mopping
nozzle').
You need to remove the object that caused the
appliance to work less well and reset the appliance.
To do so, follow the next steps. Put the appliance
upright in parking position('click') and pull the plug
out of the wall socket. Open the mopping nozzle lid,
remove the mopping brush cover and remove the
object. Reinsert the mopping brush cover, close the
mopping nozzle lid, put the plug in the wall socket
and switch on the appliance again (see chapter
'Using your AquaTrio', section 'Active protection
system is activated'). If you find no object, the active
protection system may have been activated because
the mopping brushes are too wet (see second
cause of previous problem) or because you moved
the appliance over a carpet. Pull the plug out of the
wall socket, open and close the mopping nozzle lid,
put the plug in the wall socket again, switch on the
appliance and start cleaning again.