Philips AquaTrio FC7070 Mode D'emploi page 23

Problem Possible cause
The mopping nozzle
lid is not closed
properly. The sound
of the appliance
decreases and the
appliance no longer
applies water to the
floor because the
mopping brushes do
not rotate and the
appliance does not
mop up anything.
I cannot close the The mopping brush
mopping nozzle cover is not present
lid. or is not placed
properly.
The appliance You have moved the
leaves water appliance sideways.
traces on the
floor.
You have moved the
appliance across a
threshold while it was
switched on.
You have moved the
appliance with its
nozzle touching the
floor while it was
switched off.
You lifted the
appliance up from
the floor immediately
after you switched
it off.
The wheels are
blocked.
solution
Make sure the mopping brushes and the mopping
brush cover are assembled correctly. Close the
mopping nozzle lid properly. Make sure you press
the lid until it locks with a click (see chapter 'Cleaning
and maintenance', section 'Reassembling the mopping
nozzle').
Place the mopping brush cover into the mopping
nozzle properly and then close the mopping nozzle
lid (see chapter 'Cleaning and maintenance', section
'Reassembling the mopping nozzle').
Only move the appliance forwards and backwards
(see chapter 'Using your Aqua Trio', section 'Cleaning
tips').
Make sure the mopping brushes stay in contact with
the floor. switch off the appliance before you pull it
over a threshold to prevent water traces on the floor
or to prevent water from splashing from the mopping
nozzle (see chapter 'Using your Aqua Trio', section
'Cleaning tips').
If you want to avoid water traces on the floor, move
the appliance by carrying it by its carrying handle
or by tilting it so that it rests on its wheels for easy
transport (see chapter 'storing and moving your
AquaTrio').
After you switch off the appliance, move it forwards
and backwards a few times to remove the liquid that
is present between the two mopping brushes. If you
switch off the appliance and lift it up immediately
afterwards, the water that was present between the
brushes leaves a trace of water on the floor.
Check the condition of the wheels. Remove the dirt
that blocks the wheels.
23