Cleaning The Mopping Nozzle - Philips AquaTrio FC7070 Mode D'emploi

Put the mains plug in the wall socket and
5
switch on the appliance. Let the appliance
operate until the water in the flushing tray is
used up. This takes approximately 15 seconds.
switch off the appliance and unplug it.
6
slide the mopping nozzle lid release slide in
7
the direction of the arrow (1) and open the
mopping nozzle lid (2). Remove the mopping
brush cover (3) and check if the inside is clean.
If the inside of the mopping brush cover and
the mopping brushes are still dirty, follow the
instructions in section 'Cleaning the mopping
nozzle' to clean the mopping nozzle.
If necessary, clean the flushing tray under the
8
tap and dry it with a cloth. You can also clean
the tray in the dishwasher.
6.2 Cleaning the mopping
nozzle
switch off the appliance, place the appliance
1
upright in parking position ('click') and pull the
plug out of the wall socket.
Open the mopping nozzle lid.
2
Pull at the handgrip and remove the mopping
3
brush cover. To prevent your hands from
getting dirty, lift the mopping brushes out of
the mopping nozzle by their lime green grips.
Tip:
E
Place the dirty mopping brushes on the mopping
brush cover and carry them to the sink.
Clean the mopping brushes by rinsing them
4
under the tap. If you want, you can use a liquid
household cleaner or some washing-up liquid
to clean the mopping brushes.
15