Publicité
Les langues disponibles
Les langues disponibles
MYAMTBOX. STRUCTURE OF THE DEVICE
1
Power input. WARNING! Use only power supply supplied by Allmatic
Reset button. Holding down the reset button for 10 seconds, the system returns to the factory configuration (Access
2
Point), and restores the factory password "administrator".
3
Red LED. On if MYAMTBOX is powered / On
4
Green LED. Turned on indicates that data processing (read/write) is being carried out by MYAMTBOX
5
Multicolored, green, red and yellow Leds. Status Leds
LED 5 GREEN
LED 5 YELLOW
LED 5 RED
LED 5 OFF
6
LAN cable connection
7
Antenna 433.92MHz (red-coloured)
8
Antenna 868Mhz (blue-coloured). Unused, predisposition for future functionality
RESET MYAMTBOX
With the help of a pointed object (paperweight), press and hold the button
acoustic signal, the reset is completed.
WARNING!
In case of RESET the device is placed in Access Point mode (as usual), it will not be reachable through
any other networks if it was in Client mode at the time of RESET.
MYAMTBOX following a RESET will only be reachable through its own Wi-Fi network.
SSID: allmaticdomo-xxxx 1 and the factory password will be reset: allmaticdomo
See product label example on page 3
WARNING!
THIS TYPE OF RESET DOES NOT ERASE ANY AUTOMATION PREVIOUSLY CREATED WITHIN
MYAMTBOX, NOR ITS ASSOCIATION WITH A CONTROL UNIT OR A RECEIVER.
6-1620310 - rev.2 - 25/05/2020
7
1
Flashing: Cloud OK communication
Flashing: MYAMTBOX configuration in progress
Flashing: Cloud communication absent
Cloud communication absent / No configuration in progress
8
6
5
2
for more than 10 seconds. At the end of the
2
4
3
5 / 36
Publicité
