Mounting The Support Panels; Securing The Support Bar; Mounting The Grease Exhaust Tube; Important - Pit Boss SPORTSMAN PB5000SP Guide De Montage

2. SECURING THE CONTROL BOARD TO SUPPORT LEGS
Parts Required:
2 x #10–24x½" Screw ( #D)
Installation:
• Near the Control Board, loosen the two screws connecting the front
panel to the main cabinet. Note 2A.
• Next, using another two screws, secure the front panel sides to the
front-facing support legs. Once these screws are tight, re-tighten the
two screws that were previously loosened. Note 2B.

3. MOUNTING THE SUPPORT PANELS

Parts Required:
Support Panel (#18)
2 x
8 x #10–24x½" Screw ( #D)
Installation:
• Install one support panel to the side of the unit between a front and
back support leg. Secure using two screws on each side. Ensure the
flat side of the support plate is facing outwards. Repeat the same
installation to mount the other support panel. Note illustration for
support panel arrangement.
NOTE: The support panel with two holes along the bottom should
be on the same side of the unit as the power cord exits the control
board (left side). This is important for later steps.

4. SECURING THE SUPPORT BAR

Parts Required:
1 x Support Bar (#13)
4 x #10–24x½" Screw ( #D)
Installation:
• Install the support bar to the rear of the unit between the two rear
support legs. Secure using two screws on each side. Ensure the support
bar is placed on the underside of the main cabinet, facing inwards.
Note illustration for support bar arrangement.

5. MOUNTING THE GREASE EXHAUST TUBE

Parts Required:
1 x Grease Exhaust Tube (#20)
#10–24x⅓" Screw ( #E)
2 x
Installation:
• Mount the grease exhaust tube to the underside of the main cabinet
using two screws.
IMPORTANT: Ensure there is a good seal to the main cabinet, as grease
will come from the main cabinet, flow through the exhaust tube, and
exit into the grease tray.
2
2A
3
18
18
4
13
5
20
2B
6