Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Use
Appliance is automatically managed by an electronic control system. Appliance can automatically choose the most suita-
ble operating mode, depending on the outside temperature.
When the appliance is switched on, both motors will run at a really slow speed for 3 minutes to allow repositioning of the
by-pass valve. After, motors will start up again. NOTE: this is a normal system procedure and should not be perceived as
a malfunction.
Meaning of icons/buttons in the touch area:
1
2
3
36
B
A
General
All functions can be controlled via the on-board control panel
equipped with touch screen:
A: touch area
B: display
1: Date/time (last line of the display) and Prog/Man display
2: T Ext, T Int, T Exh, T Sup display (last two lines of the display)
3: Exit without saving and return to the previous page
4
4: Speed increase (OFF, 1, 2, 3, Boost) either moving the
cursor to the line above or increasing the value
5: Speed decrease either moving the cursor to the line below or
decreasing the value
5
6: Confirmation of the current choice and go to the next page
with saving of current data
6
Publicité
