Introduction To The Subject; General Introduction - Dhollandia ELEC OPTIONS 02 Instructions De Montage

Table des Matières

Publicité

EN

1. INTRODUCTION TO THE SUBJECT

§1.1 - General introduction
The edition 02 of the electric options fitting instructions
implements following points:
new exterior control box [See Fig. 1.1]
new auxiliary control devices
amendment
to
the
European
EN1756-1:2001+A1:2008 in its newest edition.
The issue of the choice and position of the auxiliary con-
trols deals with the protection of the toes, feet and
limbs of the operator working on or around the platform. It
deals with the risk that the operator might squeeze, crush
or injure his toes or limbs between the sharp edge of the
rising or closing platform, and the rear cross member of
the loading floor of the vehicle; or between the lowering
platform and the ground.
It is generally accepted that the foot control with com-
pulsory 2-feet operation provides an efficient remedy
against this risk, since it immobilises both feet of the op-
erator on a predetermined and safe location on the plat-
form (= the buttons of the foot control).
For
other
auxiliary
1:2001+A1:2008 provides a number of guide-
lines (non-exhaustive), creating an acceptable
level of safety for the operator of the HTL. Con-
sult the European Standard (Annex B, Crushing
& shearing) for detailed information.
As a consequence, the wander lead with spiral
cable and the fixed interior control may only
be used when one or more of the methods be-
low is / are adopted.
DHOLLANDIA
1.1
Standard,
called
S008.ZK
controls,
EN1756-
1.2
S008.ZK
FIT-ELEC-GENERAL-2008-02A-Rev0 : p.26-27
S008.B
7
S094.3+1

Publicité

Table des Matières
loading

Produits Connexes pour Dhollandia ELEC OPTIONS 02

Table des Matières