O Perating Conditions; P Rotective Devises; R Otation Of Gearbox Head; G Rinding Belts - SUHNER ABRASIVE UBC 9-R Dossier Technique

Sound pressure level IEC 62841
Noise emission level
Vibration IEC 62841
Weight w/o cord set
Protection class
The specified vibration value was measured with a
standardised test procedure. It can be used to
compare products or to make an initial assess-
ment of the exposure. The vibration emissions may differ
from the specified value, depending on how the power
tool is used. Operating personnel must be protected with
defined safety measures based on the estimated expo-
sure under the actual conditions of use (these must take
into account all phases of the operating cycle, e.g. the
times when the power tool is switched OFF and the times
it is switched ON, but is not under load).
2.4 o
perAting conditions
Temperature range during operation: 0 to +50°C
Relative air humidity: 95 % at +10°C not condensed
3.
haNDLINg
3.1 p
rotectiVe deVises
3.1.1 p
rotection of the mAchine
s
tArting current limitAtion
The electronically controlled soft starting provides for
smooth starting of the machine. Due to the low machine
starting current a 16 A fuse is adequate.
t -
emperAture dependent oVerloAd protection
For protection against overheating, when a critical tem-
perature is reached the electronic safety feature switches
into the cool-down mode. Then the machine continues to
run at approx. 4.8m/s and the electronic constant speed
control is deactivated. After a cool-down time of approx.
10 - 20 sec. the machine is again ready for operation. Turn
the machine off and back on again to activate the elec-
tronic constant speed control. When the machine is at op-
erating temperature the temperature-dependent overload
protection reacts at a correspondingly earlier time.
o /
VerVoltAge restArting protection
On short-time outage of the power voltage (pulled power
connector, unstable power voltage etc.) the machine will
stop. On recovery of the power voltage the machine has
to be turned off and back on again. The machine is then
ready for operation.
3.2 r
80dB(A), K=3dB(A)
91dB(A), K=3dB(A)
2 2
5.0m/s , K=1.5m/s
1.800kg
II accessible position for special work operations.
Remove the four screws and pull off the sealing flange
package (1). Remove the four screws and carefully rotate
the gearbox head into the desired position, making sure
that it does not lift off the motor housing by more than
1 mm (2). Screw in and tighten the screws again, push
the sealing flange package back in and fix it with the four
screws.
/ o
PERaTIoN
3.3 g
speed!
Install clean grinding belts only.
3.3.1 A
To change the grinding belt, first disengage the contact
arm.
otAtion of geArBox heAd
The gearbox head can be rotated relative to the
stator housing in steps of 90° which enables the
ON/OFF switch to be brought into a more easily
rinding Belts
Use grinding belts only whose
max permitted speed is equal to or
higher than the machine's idle belt
/d
ttAching etAtching the grinding Belt
25