Ating Data; O Perating Conditions; P Rotective Devises - SUHNER ABRASIVE MINIfix 9-R Dossier Technique

2.2.4 s
Afety guArd
If a safety guard is supplied with the hand tool, it is
imperative that the safety guard be used.
2.2.5 d
rehzAhl wählen
Select a speed from the table and set this for the grinding
tool at the setting wheel.
Level 1: 4000min
-1
Level 2: 5000min
-1
Level 3: 6000min
-1
During operation never exceed the speed which
has been matched to the grinding tool specifica-
tions!
2.2.6 t /t
unr on urn off
The switch must be at the OFF position, i.e. the «0» is
visible. To switch ON the tool, press the switch, and push
it forwards until it engages audibly, i.e. the «1» becomes
bisible. Press the ON/OFF swith to trigger the blocking
and the machine shuts down.
Before turning on the machine, make sure to re-
move wrenches and adjusting tools. Before start-
ing the machine, hold the hand tool against turn-
ing!
2.3 r

Ating dAtA

2.3.1 s
pecificAtions
Voltage
Power Input
Power Output
Protection class
Type of protection
No-load speed
Sound pressure level
Weight w/o flexible shaft
Threaded connection for flexible shafts of type:
DIN 10
NA 4, NA 7
2.3.2 v
WI 7, WI 10
FH 7, FH 4
According to ISO/EN 60745.
Level 4: 7000min used for product comparisons or for an introductory as-
-1
Level 5: 8000min sessment of work breaks.
-1
Level 6: 9000min
-1
2.4 o
Temperature range during operation: 0 to +50°C
Relative air humidity: 90% at +30°C, 65% at +50°C
3.1 p
3.1.1 p
s
The electronically controlled soft starting provides for
smooth starting of the machine. Due to the low machine
starting current a 10A fuse is adequate.
t
emperAture
For protection against overheating, when a critical tem-
perature is reached the electronic safety feature switches
into the cool-down mode.
Then the machine continues to run at approx. 1,300 rpm
and the electronic constant speed control is deactivated.
After a cool-down time of approx. 10 - 20 sec. the ma-
chine is again ready for operation.
Turn the machine off and back on again to activate the
120/230/240V, 50/60Hz electronic constant speed control.
600W When the machine is at operating temperature the tem-
300W perature-dependent overload protection reacts at a cor-
II respondingly earlier time.
IP45
ibrAtion mesurement vAlues of hAnd tools
Measurement value <2.5m/s
Measurement value <2.5m/s
The specified vibration value was measured with a
standardised test method and may differ from the
actual operating value. The specified value can be
perAting conditions
To avoid strong looping movements and beaming
of the flexible shafts, the working pressure must
be reduced.
3.
haNDLINg
rotective devises
rotection of the mAchine
tArting current limitAtion
-
dependent overloAd protection
9000min
-1
76dB(A), K=3dB(A)
2.3kg
M10
see catalog
Test grinding wheel ø 50x6
/K=1.5m/s
2 2
Drive 15'000min
-1
Test grinding wheel ø 25x10
/K=1.5m/s
2 2
Drive 15'000min
-1
/ o
PERaTIoN
23