Ating Data; O Perating Conditions; Orking Instructions; S Witching On/Off - SUHNER ABRASIVE WB 4 Dossier Technique

while running and secure contact arm.
2.1.3 Attaching/detaching the belt grinding tool
Mount ring and drive roller.
Attach the belt grinding attachment, and secure this in
the position you want with the screw. Tighten the screw
only slightly!
2.1.4 A /
ttAching detAching the cOntAct Arm
Loosen (but do not remove!) the knurled nut. Replace the
contact arm, and retighten the knurled nut.
2.1.5 A /
ttAching detAching the cOntAct rOller
2.2 r

Ating dAtA

Connection
Maximum speed
Vibration EN 60745
Weight
Grinding belt and non woven:
Belt length
Belt width
Belt thickness
Belt tension
Belt speed
Drive roller
The specified vibration value was measured with a
standardised test method and may differ from the
actual operating value. The specified value can be
used for product comparisons or for an introductory as-
sessment of work breaks.
2.3 O
perAting cOnditiOns
Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3. h
aNDLINg
3.1 w

Orking instructiOns

To achieve an optimum grinding result, move
grinding belt uniformly back and forth with light
pressure.
Excessive pressure lessens the working capability of the
hand tool, as well as the life of the grinding belt.
3.2 s On/Off
witching
Hold the hand tool firmly.
Switch on the drive.
Conduct the test run without load for at least thirty
seconds. Do not use vibrating grinding belts.
You must always hold the hand tool when it is operating.
Switch off the drive when you stop working.
G16
-1
20'000min
2 2
2.1m/s , K=0.7m/s
0.600kg
305mm / 12"
3-13mm / 1/8"-1/2"
up to 4mm
40-60N
21m/s
Ø 20mm
/o
PERaTIoN
23