W Orking Instructions - SUHNER ABRASIVE UBC 9-R Dossier Technique

Loosen setscrew (1). Optimize belt run with knurled screw
(2) and secure with setscrew.
Dismantling the belt grinding attachment according to
Sec. 3.3.2.
Optimize the grinding belt tension with hexagon spanner
and mount the belt grinding attachment again.
Let the tool run without load for at least thirty seconds.
3.3.2 r /
eplAcing connecting the Belt grinding AttAchment
Attach the belt grinding attachment to the drive at the po-
sition you want, and tighten the screw.
3.3.3 r /
eplAcing connecting the contAct Arm
26
Loosen the knurled nut. Replace the contact arm, and
retighten the knurled nut.
3.3.4 r /
eplAcing connection the contAct roller
3.4 w
orKing instructions
The optimal grinding results are obtained when the grind-
ing belt is steadily moved back and forth under slight
pressure. The control electronics keep the belt speed
virtually constant during idle and load conditions for as-
sured, consistent work results. Too great a pressure re-
duces machine efficiency and the grinding belt's useful
life. The machine is equipped with an electronic control
and integrated overload protection. If the machine is over-
loaded the belt blocks briefly. Immediately remove all
loads on the machine and keep it running in the unloaded
state for a short time. Select a suitable belt speed.
When the contact pressure is too low the belt may
slip on the drive roller!