Eneral Notes On Safety; I Ncorrect Use; Rior To Taking The Machine Into Service; T Aking The Machine Into Service - SUHNER ABRASIVE LWA 81 Dossier Technique

1. n
1.1 g

enerAl notes on sAfety

This operation manual is applicable for the machine LWA
81.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The tool is designed for grinding, milling, and deburring
metal, stone, and plastic with burrs and abrasives.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Otto Suhner GmbH of Trottäcker 50, D-79713 Bad Säck-
ingen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side)
complies with the requirements under the Directive
2006/42/EG. Applied standards: EN ISO 12100, EN ISO
11148. Document Agent: M. Voyame. D-Bad Säckingen,
08/2017.
M. Voyame/Division manager
2. c
2.1 P

rior to tAKing the mAchine into serVice

The supply and exhaust hose are factory-assem-
bled already. Use oiled compressed air (see also
air quality under section 2.3). Observe national
regulations.
2.2 t
AKing the mAchine into serVice
Before connecting the tool to the com-
pressed air supply set the rotary valve to
the «OFF» position! The tool may be swit-
ched on only when the attachment have been installed
correctly.
12
S
oteS on afety
ommISSIonIng
2.2.1 t /t
urn on urn off
Switch on the tool by turning in the direction of the arrow
to the stop. Turn back to switch off the tool.
Before cutting off the compressed air supply, al-
ways set the machine to the «OFF» position so
that the tool cannot be reactivated inadvertently.
2.3 r

Ating dAtA

Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No-load speed
Sound pressure level EN ISO 15744 75dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight with hose
Air hose ID
2.4 o

PerAting conditions

Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3. h
andlIng
3.1 t
ools
Use only clean tools!
max. 6.3bar
75W
3
0.20m /min
3
0.22m /min
1 drops/min
-1
80'000min
2 2
2.1m/s , K=1.7m/s
2/4/4
0.270kg
Ø 5mm / 3/16"
/o
peratIon