Identification; Product Description And Type Designation; Product Marking Label - Videotec HGV Manuel D'instructions

• This device was designed to be permanently
secured and connected on a building or
on a suitable structure. The device must be
permanently secured and connected before any
operation.
• Comply with all the national standards during the
device installation.
• Installation category (also called Overvoltage
Category) specifies the level of mains voltage
surges that the equipment will be subjected
to. The category depends upon the location
of the equipment, and on any surge voltage
protection provided. Equipment in an industrial
environment, directly connected to major
feeders/short branch circuits, is subjected to
Installation Category III. If this is the case, a
reduction to Installation Category II is required.
This can be achieved by use of an insulating
transformer with an earthed screen between
primary and secondary windings, or by fitting
UL listed Surge Protective Devices (SPDs) from
live to neutral and from neutral to earth. Listed
SPDs shall be designed for repeated limiting of
transient voltage surges and the following rated
operation conditions: Type 2 (SPDs permanently
connected to the power network and intended
for installation on the load side of the service
equipment); Nominal Discharge Current (In)
20kA min. For example: FERRAZ SHAWMUT,
STT2240SPG-CN, STT2BL240SPG-CN rated
120Vac/240Vac, (In=20kA). Maximum distance
between installation and reduction is 5m.
• Any device which could be installed inside the
product must comply with the current safety
rules.
• The product is designed to house only cameras
that are properly certified according to IEC/UL
60950-1 or IEC/UL 62368-1 (7W max).
MNVCHGV_2222_EN
• A power disconnect device must be included
in the electrical installation, and it must be very
quickly recognizable and operated if needed.

4 Identification

4.1 Product description and type
designation
The HGV housing is ideal for outdoor monitoring
of great distances for applications in public safety,
environmental monitoring and border surveillance
or at harbours, along coastlines and at airports.
Robust housing with aluminium base designed to
simplify installation and service and guarantee total
protection in all environmental conditions.
The big dimensions of this camera housing make it
suitable to contain the largest zoom lenses of the
market.
For easy access during the installation and the
adjustment of the camera, it is possible to remove
the upper part of the housing body, which is held by
a robust safety cord.

4.2 Product marking label

See the label attached to the product.
5