Eneral Notes On Safety; I Ncorrect Use; Rior To Taking The Machine Into Service; T Aking The Machine Into Service - SUHNER ABRASIVE LWA 80 Dossier Technique

1. N
1.1 g

enerAl notes on sAfety

This operation manual is applicable for the machine LWA
80.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The tool is designed for grinding, milling, and deburring
metal, stone, and plastic with milling cutters and grinding
attachments.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner GmbH, Trottäcker 50, D-79713 Bad Säckin-
gen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2006/42/
EG. Applied standards: EN ISO 12100, EN ISO 11148.
Document Agent: T. Fischer. D-Bad Säckingen, 10/2019.
T. Fischer/Managing Division manager
2. C
2.1 P

rior to tAKing the mAchine into serVice

Use oiled compressed air (see also air quality un-
der section 2.3). Observe national regulations.
2.1.1 m
ount the suPPly hose
Screw connection nipple into the valve body, invert suply
hose through connection nipple and fix it with hose clamp
(available as an accessory).
16
S
oTES oN aFETy
ommISSIoNINg
2.2 t
AKing the mAchine into serVice
Before connecting the tool to the com-
pressed air supply set the sleeve to the
«OFF» position! The tool may be switched
on only when the attachment have been installed correct-
ly.
2.2.1 t /t
urn on urn off
Turning on the machine by moving the sleeve in the ar-
row direction. Off by moving the sleeve in the opposite
direction.
Before cutting off the compressed air supply, al-
ways set the machine to the «OFF» position so
that the tool cannot be reactivated inadvertently.
2.2.2 s
etting the Air direction
The side air direction can be adjusted by turning the
sleeve.
2.3 r

Ating dAtA

Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No-load speed
Max. wheel diameter
Max. chuck diameter
Sound pressure level EN ISO 15744 84dB(A), K=3dB(A)
Sound power level EN ISO 15744
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight with hose
max. 6.3bar
75W
0.22m /min
3
0.24m /min
3
about 1 drops/min
80000min
-1
10mm
3mm / 1/8"
96dB(A), K=3dB(A)
1.78m/s , K=0.93m/s
2 2
2/4/4
0.120kg