Tools Required - R&G LP0176BK Instructions De Montage

LEGEND
ITEM 1= LICENCE PLATE BRACKET (TB0176 PT1) (x1).
ITEM 2= INDICATOR MOUNTING PLATE (TB0176 PT2) (x1).
ITEM 3= M6x6mm LONG BUTTON HEAD BOLTS (x7).
ITEM 4= LICENCE PLATE ADAPTOR PLATE (TB0092 PT1) (x1).
ITEM 5= RUBBER GROMMETS (RB0003) (x3).
Page | 2
ITEM 6= BAG OF ELECTRICAL CONNECTORS (CON4) (x1).
ITEM 7= REFLECTIVE (REFL1) (x1).
LIGHT SHROUD (LH0004) (x1).
ITEM 8= CABLE CLIPS (CLIP1) (x5).
ITEM 9= LICENCE PLATE LIGHT ASSEMBLY (LA0002) (x1).
ITEM 10=250mm LENGTH OF HEAT SHRINK (666-896) (x1).
ITEM 11= SMALL RUBBER GROMMETS (RB80-30-00) (x2).
ITEM 12= M6 WASHERS (x2) NOT SHOWN.
Please note that in cases where kits are packed with rubber washers holding the components
FITTING INSTRUCTIONS

REMOVE PILLION SEAT USING KEY (SEE PICTURE 1).

UNCLIP AND DISCONNECT WIRING PLUG (LARGER ARROW IN PICTURE 2).

UNDO AND REMOVE CLAMP SCREW (SMALLER ARROW IN PICTURE 2).

UNCLIP ALARM FROM ITS MOUNTING BRACKET (DO NOT UNPLUG) AND
REST ON FUSE BOX (TO ALLOW ACCESS TO ALARM MOUNTING BRACKET).

REMOVE PLASTIC ALARM MOUNTING BRACKET (GENTLY SQUEESE AND
TWIST TO UNCLIP FROM REAR SUB-FRAME). THIS ALLOWS CABLE TO GO
THROUGH ACCESS HOLE.

REMOVE THREE BOLTS FROM THE UNDERSIDE (SEE PICTURE 3 FOR
POSITION) TO ALLOW ORIGINAL LICENCE PLATE BRACKET TO BE
onto the bolt – the rubber washers should be thrown away!

TOOLS REQUIRED


Set of metric Allen keys to include 4mm A/F sizes.

Set of Torx keys to include T20 and T25 sizes.

Electrical pliers/crimps.
1
PICTURE

Super glue.
LP0176
2
PICTURE