R&G LP0176BK Instructions De Montage page 4

Page | 4








5
PICTURE
CONNECT WIRING PLUG SOCKETS AS ORIGINAL (IF THE LICENCE
PLATE ILLUMINATOR FAILS TO WORK PLEASE SWOP THE CONNECTORS
OVER).
REFIT ALARM MOUNTING BRACKET AS ORIGINAL.
REMOUNT AND SECURE ALARM AS ORIGINAL.
REFIT PILLION SEAT.
REFIT LICENCE PLATE (IT MAY REQUIRE DRILLING).
IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND
PLACING IT FAR DOWN ON THE LICENCE PLATE HANGER, THERE IS
A SMALL CHANCE OF THE LICENCE PLATE HITTING THE BACK
WHEEL UNDER HEAVY LOAD AND OVER LARGE BUMPS IN THE
ROAD. IT IS YOUR RESPONSIBILITY TO CHECK FOR THIS
POSSIBILITY AND TAKE AVOIDING ACTION. FAILURE TO CHECK
THIS COULD RESULT IN SERIOUS INJURY.
DEPENDING ON LOCAL LAWS, ATTACH ENCLOSED RED REFLECTIVE
TAPE IN AN APPROPIATE LOCATION.
TEST THE INDICATORS (TURN SIGNALS) (DEPENDING ON THE TYPE OF
INDICATORS BEING USED YOU MAY HAVE TO USE RESISTORS TO GET
THE CORRECT FLASH RATE), LICENCE PLATE ILLUMINATOR AND ALL
LIGHTS BEFORE RIDING.
LP0176
6
PICTURE