Publicité
Les langues disponibles
Les langues disponibles
6. The C.P.G. Function Switch
Refer to page 16 for the C.P.G. function that will indicate the proper
angle so that the height of the cuff is the same level as your heart.
1. After step 6 in page 8, press the
"
" concerning the C.P.G. function.
2. Press the
button to store the selection.
SET
3.
If you do not use my C.P.G. function, press
to turn off. Proceed to "8. Measurement".
If you use my C.P.G. function, proceed to "7. Selecting the
C.P.G. and my C.P.G.".
7. Selecting the C.P.G. and my C.P.G.
You can select an indicator either the C.P.G. function or my C.P.G. .
Preset a proper posture (wrist angle) in memory if you use the my C.P.G. .
1. Adjust and keep the height of the blood pressure monitor to
the same level as your heart using your wrist angle.
2. Select an indicator using the
Indicator
The C.P.G. function is used. (my C.P.G. function : OFF )
.....
Data of my C.P.G. is deleted. Proceed to step 3.
Indicator
my C.P.G. function is ON and the current angle is stored
.....
when switched to the indicator . Proceed to step 3.
3. Press the
button to turn off the device.
START
button to select either " " or
button
START
button.
English 10
From step 6 of page 8
The C.P.G. function
button
Press the
To "7. Selecting the C.P.G. and my C.P.G." or
button and to "8. Measurement"
START
The C.P .G. indicator
Step 1 [Adjust and keep the height
of the device (wrist angle) ]
HIGH (Orange light)
Correct Height (Blue light)
LOW (Orange light)
Step 2 [Select The C.P .G. or my C.P .G.]
The C.P.G. function
button
Ex.: user 1
button and to "8. Measurement"
START
button
SET
My C.P.G.
Publicité
