Télécharger Imprimer la page

Quickie Life T Notice D'utilisation page 28

Masquer les pouces Voir aussi pour Life T:

Publicité

Les langues disponibles

Les langues disponibles

Stabilizing Bar
Folding stabilising bar
This bar is used to stabilize the backrest.
To be able to fold the wheelchair, the release lever must be
pushed inwards (Fig. 6.31) or released and the stabilising must
be flipped downwards. When unfolding the wheelchair, please
make sure that the stabilising bar is locked into position.
Fig. 6.31
Sideguards
Desk Sideguard, Flip-Up, Detachable with Short or Long
Armrests, Height-Adjustable (Fig. 6.32 - 6.33)
Adjust the height of the armrest as follows: Slide the knob (1)
forward until it stops. Adjust the armrest (2) to the desired
height. Slide the knob toward the back and push the armrest (2)
down until you can hear it click into place. Always make sure
that the sideguards have locked into place properly. To flip the
armrest up, lift the handle (3) to unlock the sideguard.
WARNING!
Neither the sideguards nor the armrests are to be used for
lifting or carrying the wheelchair.
2
Fig. 6.32
1
3
3
28
Fig. 6.33
Central support
Installation: Slide the arm post into the receiver, located on the
wheelchair frame, until it stops
Height adjustment:
Slide the armrest post out of the receiver.
Adjust the position of the height adjustment bracket (1) by
removing the screw (2) and moving it to the desired posiion.
Re-fit the screw and tighten it.
Slide the arm rest post back into the receiver, (Fig. 6.34).
Armpad Position:
The armpad position can be adjusted by releasing the screws
(3), then moving the arm pad to the desired position. Re-tighten
the screws, (Fig. 6.34).
Adjusting Armrest Receiver
The tightness of the armrest receiver can be adjusted (tightened
/loosened) by means of the 2 screws (1) - (Fig. 6.35).
Sideguard With Clothes Protector (Fig. 6.36)
The clothes protector prevents clothes getting dirty from spray
water. You can set the position in relation to the rear wheel by
moving the sideguard.
To do this, remove the fixing screws (1 and 2).
After setting to the desired position, re-tighten the screws (see
the page on torque).
WARNING!
Neither the sideguards nor the armrests are to be used for
lifting or carrying the wheelchair
Fig. 6.34
3
1
2
Fig. 6.36
1
Fig. 6.35
1
2
Life T Rev.J

Publicité

loading