Mounting The Wall Bracket - Muller licht Tint Mode D'emploi

Mounting the wall bracket

1. Remove the protective film from both sticky pads.
2. Press the bracket with some force against a clean, dry
and dust-free surface.
Screwing in the wall bracket
NOTICE!
Make sure there are no pipes or wires in the wall where you
intend to drill.
Depending on the surface, the wall bracket can be attached
to the wall with screws and wall plugs if required. Screws
and wall plugs are included with the bracket.
1. Separate the two halves of the bracket.
2. Use the rear of the bracket as a stencil to mark where
you will drill.
3. Drill the holes and insert the wall plugs (if needed) in the holes.
4. Screw the rear of the bracket onto the wall.
5. Place the upper part of the bracket on the screwed lower part.
The bracket can now be used.
SETUP 61