Reset - Muller licht Tint Mode D'emploi

The tint product will blink in the order in which they are
stored in the tint remote control.
5. Hold down the group button again until the selected
tint product starts to blink again.
The group display for group 1 will also light up.
6. Using the group button, select (if necessary) the
group to which you would like to add the tint product
while the feedback display still is blinking red/green. The
selected tint product will be assigned to default group
(=group 1) if group button is not pressed at all. After ap-
prox. 10 seconds, the tint product will be added to the se-
lected group and the feedback display will stop blinking.
Wait this long, not pressing any buttons during this time.
The procedure will then end and you can use the extend-
ed group as normal.

RESET

Resetting the tint product
Resetting the tint product is only required in exceptional
cases, such as when the remote control has had to be reset.
Note: All settings (such as the link to the remote control)
are reset. The tint product is then returned to coupling
mode.
1. Switch the tint product on and off 5 times (follow the
instructions of the respective product)
2. Switch the tint product on again. It will now begin to cycle
through its colors. The reset has occurred as desired and
you can now use the tint product as normal using your
remote control or other Zigbee system.
68 ENGLISH